YASKAWA DX100 Operator's Manual page 521

155507-1CD
DX100
9 General Purpose Application
9.3 Using Files
(4) FREQUENCY
– Specifies the weaving frequency if "SPEED (3)" is set to "0: FREQ."
Note that the maximum frequency is determined by the amplitude as
illustrated in the graph below. Specify a frequency within the
allowable range. Note that the graph only indicates tentative values.
Amplitude 60
(mm)
50
40
30
20
10
Maximum Frequencies for Different Amplitudes
(5) PATTERN
– If "MODE (2)" is set to "0: SINGL," the angle must be specified.
Wall direction
"Mode
– If "MODE (2)" is set to "1: TRI" or "2: L", the following information on
the triangle must be specified: vertical distance, horizontal distance,
and angle.
Wall direction
Vertical
distance
Horizontal
distance
9-32
0 12345
Frequency(Hz)
Angle : 0.1 to
Horizontal
direction
Angle

" (Weave Type): Single oscillation
Angle
Angle: 0.1 to
Vertical/horizontal distance:
Horizontal direction

"Mode " (Weave Type): Triangle or
L-type oscillation
180.0°
180.0°
1.0 to 25.0mm
521 of 554
RE-CSO-A037