Hold Operation; Hold] On The Programming Pendant; Hold By External Input Signal (System Input) - YASKAWA DX100 Operator's Manual

155507-1CD
DX100

4.5.3 Hold Operation

4.5.3.1 [HOLD] on the Programming Pendant




4.5.3.2 Hold by External Input Signal (System Input)



4 Playback
4.5 Playback with Reserved Start
Hold operation causes the manipulator to stop all motion. It can be
performed by the following buttons or signal.
• [HOLD] on the programming pendant
• External Input Signal (system input)
• Hold button for the station axis
[HOLD] lamp lights while it is held down. At the same time,
SUPPLE-
[START] lamp goes OFF.
MENT
Hold
1. Press [HOLD] on the programming pendant.
– The manipulator stops temporarily.
– The [HOLD] lamp lights while the [HOLD] button is held down.
Release
1. Press the start button on the suspended station.
– The manipulator restarts its operation from the position where it was
stopped.
Hold
1. Input ON signal to the external input (system input) specified for the
hold operation.
– The manipulator stops temporarily.
External holding
– The hold lamp for the external output signal lights.
– The [HOLD] lamp on the programming pendant lights and the
[START] lamp turns OFF.
Release
1. Input OFF signal to the external input (system input) specified for the
hold operation.
– Hold is released.
2. To continue the operation, press the start button on the suspended
station.
– The manipulator restarts its operation from the position where it was
stopped.
4-34
223 of 554
RE-CSO-A037