Switching The Axis Operation Control Group; S2C540 "Choosing Method Of Notifying The Change Of Axis Operation Control Group When Switching The Active Window - YASKAWA DX100 Operator's Manual

DX100

6.7.5 Switching the Axis Operation Control Group

6.7.5.1 S2C540 "Choosing Method of Notifying the Change of Axis Operation
6 Convenient Functions
6.7 Multi Window Function
The appropriate control group for axis operation is automatically selected
in accordance with the window status or its operation in the active window.
Due to this function, when the general-purpose display area is in multi
window mode, the control group for axis operation can vary depending on
the window which is active at the time.
To avoid unexpected control group to function and for the better safeness,
the change of the control group with the [MULTI] key operation or touching
operation when switching the active window is notified to the user.
The change of the control group for axis operation due to
other than [MULTI] key operation or touching operation; due
SUPPLE-
to the switch of the window by selecting main menu, is not
MENT
notified to the user.
Control Group when Switching the Active Window"
The method to notify the change of control group for axis operation due to
the switch of active window can be changed with parameter.
• Setting Value:0
– Keep displaying the message in the human interface display area
for three seconds.
– Message "Control group switched by switching the active window" is
displayed.
6-74
155507-1CD
RE-CSO-A037
314 of 554