Manual Upgrade On A Dual Supervisor Switch; Preparing For A Manual Installation - Cisco DS-X9530-SF1-K9 - Supervisor-1 Module - Control Processor Configuration Manual

Mds 9000 family

Table of Contents

Software Images

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Extracting "system" version from image bootflash:/i-1.3.0.104.

Extracting "kickstart" version from image bootflash:/b-1.3.0.104.

Extracting "loader" version from image bootflash:/b-1.3.0.104.

switch# show install all status

This is the log of last installation.

Verifying image bootflash:/b-1.3.0.104

Verifying image bootflash:/i-1.3.0.104

Extracting "system" version from image bootflash:/i-1.3.0.104.

Extracting "kickstart" version from image bootflash:/b-1.3.0.104.

Extracting "loader" version from image bootflash:/b-1.3.0.104.

Manual Upgrade on a Dual Supervisor Switch

If you are a new user, use the install all command to perform a software upgrade. This section is for

administrators or individuals who are completely familiar with specific switch functions.

You can manually upgrade the BIOS and the loader in any Cisco MDS switch using the procedures

provided in this section. This upgrade process requires you to implement some or all procedures

depending on your switch or network configuration.

To perform a manual upgrade for a dual supervisor switch, follow these steps.

"Preparing for a Manual Installation" section on page 6-19

"Upgrading a Loader" section on page 6-21

"Upgrading the BIOS" section on page 6-23

To prepare any Cisco MDS 9000 Family switch for a manual software installation, follow these steps:

Log into the switch through the console port, an SSH session, or a Telnet session.

Create a backup of your existing configuration file, if required (see the

section on page

OL-6973-03, Cisco MDS SAN-OS Release 2.x

Manual Upgrade on a Dual Supervisor Switch

<<<<<< log of last install

"Saving the Configuration"

Cisco MDS 9000 Family Configuration Guide