Table of Contents
Advertisement
Attaching Cables to the DC Power Supply
Attaching Cables to the DC Power Supply
Note
When installing DC power supply, use 14 AWG, 90°C wires. Always ensure that the building's installation
for short-circuit (overcurrent) protection does not exceed 15A.
To attach the DC power supplies:
Step 1
Open the DC power supply guard.
Step 2
Attach the DC supply wires in the designated screws. See figure below.
Figure 18: Connecting the DC Power Supply Wires
Step 3
Close the DC power supply guard.
Cisco NCS 4201 Hardware Installation Guide
46
Installing the Cisco NCS 4201
Advertisement
Table of Contents
