Advertisement
What To Do Next
Default Settings on the Express Setup Page
Table 4-1
Table 4-1
Setting
System Name
Configuration Server Protocol
IP Address
IP Subnet Mask
Default Gateway
SNMP
SSID
Broadcast SSID in Beacon
Role in Radio Network
Optimize Radio Network for
1. During Install Mode, the SSID is autoinstall.
2. After a static IP address is assigned or the role is changed from Install, the SSID is tsunami.
What To Do Next
After your bridge has basis settings, you need to complete your bridge's configuration. You might need
to adjust the output power level and other network and security settings.
Output Power Level
Your bridge's output power level might require adjustment in the following conditions:
•
•
To configure your bridge's output power level, refer to the Cisco Aironet 1400 Series Software
Configuration Guide.
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide
4-8
D R A F T - C I S C O C O N F I D E N T I A L
lists the default settings for the settings on the Express Setup page.
Default Settings on the Express Setup Page
The bridge's output power level must be reduced when using an external dish antenna or when using
the integrated antenna in a multipoint configuration (refer to
page
C-2).
When bridges are located less than 328 ft (100 m) apart, you should reduce their output power to
avoid overloading the bridge's receivers.
Chapter 4
Default
bridge
DHCP
Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 10.0.0.1
Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 255.255.255.224
Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 0.0.0.0
defaultCommunity
Read Only
1
2
autoinstall
or tsunami
Yes
Install
Throughput
Configuring the Bridge for the First Time
"Maximum Power Levels" section on
OL-4072-01
Advertisement
Chapters
