Restore Factory Settings - Cisco NCS1004 Manual

Restore Factory Settings

RP/0/RP0/CPU0:ios#show controllers hundredGigECtrlr 0/0/0/5
Thu Apr 23 10:47:48.020 UTC
Operational data for interface hundredGigECtrlr0/0/0/5:
State:
Phy:
Autonegotiation disabled.
Operational values:
Restore Factory Settings
You can restore the factory settings on the NCS 1004. The entire system configuration, including usernames,
passwords, and IP addresses, is removed. You can perform this operation only through the console port and
not on the management interface. To restore NCS 1004 to factory settings, use the commit replace command.
After the commit replace operation completes, you must perform the IOS XR reload operation.
The commit best-effort command merges the target configuration with the running configuration and commits
only valid changes (best effort). Some configuration changes might fail due to semantic errors.
Example
RP/0/RP0/CPU0:ios#configure
RP/0/RP0/CPU0:ios(config)#commit replace
Tue Sep 24 09:36:59.430 UTC
This commit will replace or remove the entire running configuration. This
operation can be service affecting.
Do you wish to proceed? [no]: yes
RP/0/RP0/CPU0:ios(config)#exit
RP/0/RP0/CPU0:ios#reload
Tue Sep 24 09:38:12.881 UTC
Standby card not present or not Ready for failover. Proceed? [confirm]
Preparing system for backup. This may take a few minutes especially for large configurations.
Configuring Controllers
38
Administrative state: enabled
Operational state: Up
LED state: Green On
Maintenance: Enabled
AINS Soak: None
Total Duration: 0 hour(s) 0 minute(s)
Remaining Duration: 0 hour(s) 0 minute(s) 0 second(s)
Laser Squelch: Disabled
Media type: Not known
Speed: 10Gbps
Duplex: Full Duplex
Flowcontrol: None
Loopback: Internal
Inter-packet gap: standard (12)
BER monitoring:
Not supported
Holdoff Time: 0ms
Status report: node0_RP0_CPU0: BACKUP INPROGRESS
Configuring Controllers