Verify Node Status - Cisco NCS 1002 System Setup And Software Installation Manual

Perform Preliminary Checks
NAME: "0/FT0", DESCR: "Network Convergence System 1000 Fan"
PID: NCS1K-FTA
NAME: "0/FT1", DESCR: "Network Convergence System 1000 Fan"
PID: NCS1K-FTA
NAME: "0/FT2", DESCR: "Network Convergence System 1000 Fan"
PID: NCS1K-FTA
NAME: "0/PM0", DESCR: "Network Convergence System 1000 2KW AC PSU"
PID: NCS1K-2KW-AC
NAME: "0/PM1", DESCR: "Network Convergence System 1000 2KW AC PSU"
PID: NCS1K-2KW-AC
You can verify if any QSFP or CFP has been removed from the NCS 1002.

Verify Node Status

You can verify the operational status of all the nodes using the show platform command. You can execute
this command independently from both the Cisco IOS XR EXEC and System Admin EXEC modes.
To verify the operational status of all the nodes, perform the following procedure.
Procedure
Step 1 show platform
When you execute this command from the XR EXEC mode, the status of the Cisco IOS XR is displayed.
Verify that the node state is Operational and admin state is UP.
Example:
RP/0/RP0/CPU0:ios# show platform
Wed Feb 28 03:28:40.004 UTC
Node
--------------------------------------------------------------------------------
0/RP0/CPU0
If the Cisco IOS XR is not operational, no output is shown in the result. In this case, verify the state of SDR
on the node using the show sdr command in the System Admin EXEC mode.
Step 2 admin
Enters System Admin EXEC mode.
Example:
RP/0/RP0/CPU0:ios# admin
Step 3
show platform
Displays information and status for each node in the system.
Example:
, VID: V01, SN: N/A
, VID: V01, SN: N/A
, VID: V01, SN: N/A
, VID: V01, SN: POG2041J0BW
, VID: V01, SN: POG2041J01C
Type
NCS1K-CNTLR(Active)
System Setup and Software Installation Guide for Cisco NCS 1002
State Config state
IOS XR RUN NSHUT

Verify Node Status

21