Nand Flash/Pc Card Controller - STMicroelectronics RM0365 Reference Manual

Flexible static memory controller (FSMC)
Bits 15:8 DATAST: Data-phase duration.
These bits are written by software to define the duration of the data phase (refer to
Figure 43), used in asynchronous SRAM, PSRAM and NOR Flash memory accesses:
0000 0000: Reserved
0000 0001: DATAST phase duration = 1 × HCLK clock cycles
0000 0010: DATAST phase duration = 2 × HCLK clock cycles
...
1111 1111: DATAST phase duration = 255 × HCLK clock cycles (default value after reset)
Bits 7:4 ADDHLD: Address-hold phase duration.
These bits are written by software to define the duration of the address hold phase (refer to
to Figure
0000: Reserved
0001: ADDHLD phase duration = 1 × HCLK clock cycle
0010: ADDHLD phase duration = 2 × HCLK clock cycle
...
1111: ADDHLD phase duration = 15 × HCLK clock cycles (default value after reset)
Note: In synchronous NOR Flash accesses, this value is not used, the address hold phase is always
1 Flash clock period duration.
Bits 3:0 ADDSET: Address setup phase duration.
These bits are written by software to define the duration of the address setup phase in HCLK cycles
(refer to Figure 31
0000: ADDSET phase duration = 0 × HCLK clock cycle
...
1111: ADDSET phase duration = 15 × HCLK clock cycles (default value after reset)
Note: In synchronous accesses, this value is not used, the address setup phase is always 1 Flash
clock period duration. In muxed mode, the minimum ADDSET value is 1.
14.6

NAND Flash/PC Card controller

The FMC generates the appropriate signal timings to drive the following types of device:
•
8- and 16-bit NAND Flash memories
•
16-bit PC Card compatible devices
The NAND Flash/PC Card controller can control three external banks, Bank 2, 3 and 4:
• Bank 2 and Bank 3 support NAND Flash devices
•
Bank 4 supports PC Card devices.
Each bank is configured through dedicated registers
memory parameters include access timings (shown in
269/1080
43), used in asynchronous multiplexed accesses:
to Figure 43), used in asynchronous accesses:
DocID025202 Rev 7
(Section 14.6.8). The programmable
Table 73) and ECC configuration.
RM0365
Figure 31 to
Figure 31