CHAPTER 4 EXTERNAL BUS INTERFACE
4.9.3
Connecting SDRAM/FCRAM to Many Areas
This section shows the connecting SDRAM/FCRAM to many areas.
■ Connecting SDRAM/FCRAM to Many Areas
SDRAM/FCRAM can be set for CS6 and CS7 areas. When connecting SDRAM/FCRAM to 2
areas, connect the same type of modules.
More precisely, connect the modules common in the following register settings.
•
Area configuration register (ACR): Set all of the DBW1 to DBW0, BST1 to BST0, and TYP3
•
Area wait register (AWR):
•
Memory setting register (MCR):
•
Refresh control register (RCR):
To enable the two areas at a time, execute the power-on sequence, auto-refresh, and self-
refresh at the same time.
230
to TYP0 bits to the same.
Set all the bits to the same.
All the settings are the same as the registers are common.
All the settings are the same as the registers are common.