Initial Controller Power Up - MCi iControl User Manual

Initial Controller Power Up

After AC power is connected, you are ready to temporarily power up the controller and check to
see that power buses inside the controller cabinet are providing their proper outputs.
Caution
This procedure assumes that no field wiring has been connected to the controller. If field
wiring has been connected, disconnect it before beginning this procedure. Before applying
power, physically check all power resistors and other components located in the resistor and
controller compartments. Components loosened during shipment may cause damage.
1. On the iBox, verify:
• Inspection switch UP (Inspection mode selected)
• Controller Stop Switch DOWN (Stop selected)
• Test switch ON
• All other iBox slide switches DOWN (Off)
These switch settings prevent the elevator from moving when the controller is powered up.
Note
The controller microprocessor board has battery backup for logic retention. An insulator pre-
vents the battery from discharging during shipment. Remove the insulator now if has not
already been done.
AC Voltage Verification and Wiring
NOT FUNCTIONAL
2
2-19