MCi iControl User Manual page 332

For ac elevators
Table of Contents

Advertisement

Troubleshooting
Table 6.3 iControl Messages
Nudging Front, NUDGING FRONT
Description: This event is logged when front door nudging operation is invoked.
Car Reaction: Front doors start closing at reduced speed and torque.
Nudging Operation
Description: The doors are operating in Nudging mode. (Passenger operation).
Nudging Rear, NUDGING REAR
Description: This event is logged when rear door nudging operation is invoked.
Car Reaction: Rear doors start closing at reduced speed and torque.
Other Cars Alternate Fire Sensor Recall, OTHER CARS ALT FIRE
Description: Alternate fire recall due to active or latched smoke detector input(s) from the hoistway or
machine room of other cars in the system.
Car Reaction: Car proceeds to the user-defined alternate fire recall floor. Once at the recall floor, door opera-
tion is according to the user-defined door operation under fire recall operation.
Troubleshooting:
1. If in error, inspect the sensors, inputs, and connections.
2. Related Inputs: Other Cars Alt Recall sensor inputs as indicated on job prints.
Other Cars Main Fire Sensor Recall, OTHER CARS MAIN FIRE
Description: Main fire recall due to active or latched smoke detector input(s) from the hoistway or machine
room of other cars in the system.
Car Reaction: Car proceeds to the user-defined main fire recall floor. Once at the recall floor, door operation
is according to the user-defined door operation under fire recall operation.
Troubleshooting:
1. If in error, inspect the sensors, inputs, and connections.
2. Related Inputs: Other Cars Main Recall sensor inputs as indicated on job prints.
PARAM CHNG-RESET CAR, see Global Parameter Update, Reset Controller
Passenger Operation, Passenger. Normal operation status message.
Photo Eye Antinuisance
Description: This event is logged when car calls are canceled due to a user-defined number of car calls being
registered without interruption of the photo eye device.
Car Reaction: All car calls are cancelled.
Troubleshooting:
1. Check the user defined options related to the operation. (iView/Car Operation/Passenger/Anti Nuisance.)
2. Check the photo eye device and related inputs.
Position Cartop Offset Fault, POSTN CARTP OFFST FLT
Description: Each time the car stops, it obtains position information from the cartop position encoder. If the
reported position varies from the position last reported at this location by more than two feet, this fault is
generated.
Car Reaction: Emergency stop. Motor and brake contactors immediately dropped.
Troubleshooting: Perform a Terminal Synchronization (Pattern Configuration screen>Common tab>Position
Synchronization.
Position Location Error Fault, POSTN LCTN ERROR FLT
Description: If the difference between the learned position of a floor (magnet) and the currently indicated
position of that floor (magnet) is greater than 2 feet, this fault is generated.
Car Reaction: Car will perform a terminal synchronization.
Troubleshooting:
1. Check that the iLand landing system is properly installed and adjusted. (Refer to Section 3 of this guide.)
6-56 Manual # 42-02-2222
iControl Messages

Advertisement

Table of Contents
loading

Related Products for MCi iControl

Table of Contents