Section 9. Iview - Controller View; About This Section; Selecting Controller View - MCi iControl User Manual

About this Section

This section contains detailed information about:

• Selecting Controller view:

• Controller View Windows and
and information about the parameters on each.
Selecting Controller View
iView is used to view and adjust the Controller and System parameters. iView is divided into
two main sections:
• Controller View - used to view and adjust the controller parameters, e.g., Brake, Drive,
Pattern, Car Operation, etc. When iView first connects to an iController, the Controller
view is displayed.
• System View - used to view and adjust the System parameters, e.g., Dispatching, Parking,
Emergency Power, Security, etc. When iView is connected to a central dispatcher (iCen-
tral), the Controller and System buttons are missing and System view is always displayed.
Please refer to "Selecting System View" on page
To select Controller view, click the Controller view button at the top of the iView screen.
iView - Controller View
tabs: A complete list of iView windows and tabs,
• About this Section
• Selecting Controller View
• iV Windows and tabs
IEW
• Hoistway
• Operational Status tab
• Diagnostic tabs
• Configuration tabs
• Setup tabs
• Data Trap
• Outputs
• Safety tests
• Virtual Oscilloscope
• Layouts
• Call registration
• Firmware update
10-1.
9
9-1