Verifying The Safety Configuration; Exit Construction Mode - MCi iControl User Manual

Verifying the Safety Configuration

Verify that the safety options required for this job are checked on the iView Safety screen.
refer to "Setup - Safety - Configuration Tab" on page
not operational, will require a jumper to allow the car to operate on Inspection (inputs must be
high).

Exit Construction Mode

Perform the following checks before exiting construction mode:
1. On the iBox, verify that the green CARTOP LED is lighted indicating that the controller
is communicating with the cartop processor board. If not, check the CARTOP LINK wir-
ing. The terminals must be connected as follows: (iBox TX+ and TX- terminals to CTP
board RX+ and RX- terminals. iBox RX+ and RX- terminals to CTP board TX+ and TX-
terminals.)
2. In iView, display the Operational Status tab. Run the car and monitor the Position - Log-
ical and Position - Cartop values. Verify that the values increase when the car is moving
in the up direction. The value(s) could be negative, in which case they must become less
negative when the car moves in the up direction.
3. As the car moves, monitor the Leveling Sensor indicators on the Operational Status tab.
Verify that the sequence is correct. When the car is traveling in the up direction, the
sequence should be, Front/Rear Up leveling marker, followed by Front/Rear Door zone,
followed by Front/Rear Down leveling marker.
To exit construction mode:
1. From the iView Write privilege menu, select Acquire.
The iBox LCD will display a message requesting write privileges for iView.
2. On the iBox, press the "Yes" (1) softkey to assign write privileges to iView.
3. Open the Safety screen.
4. Click the Construction Mode check box (remove check mark).
5. Click the Send button.
6. You must then re-learn the Safety Configuration.
Configuration" on page
Verifying the Safety Configuration
9-147. Any options that are checked, but
2-46.
Please refer to "Learning the Safety
Please
3
3-25