MCi iControl User Manual page 665

• EP - Car selected for emergency power output: Active when the car is given power dur-
ing emergency power operation. Essentially this is the combination of outputs EP - Car
selected to run and EP - Car selected to recall. If the car is given power to operate at
any time during emergency power operation, the output will be activated. Select the
Car ID in the Association column.
• EP - Car selected to recall output: Active when the car is given power to Recall during
Emergency Power operation. Select the Car ID in the Association column.
• EP - Car selected to run output: Becomes active when the specified car is selected to
operate. The output is always cleared during Freeze and Recall phases and during
Power transfer activation upon stopping at a floor. Select Car ID in Association col-
umn.
Cross Registration: Cross registration is intended for use during modernization projects. It
provides an interface between cars in a newly installed iControl group and cars in an existing
(legacy) group. The iCue dispatcher will preferentially assign hall calls to iControl cars unless
the estimated time of arrival for an iControl car exceeds a limit programmed by the user (Cross
Registration screen). In this case, iCue will assign the call to the legacy group dispatcher. Hall
Call Eligibility for legacy cars must be programmed into iCue, just as they are in the legacy
group, to ensure that only cars that are eligible are dispatched to answer calls.
• Cross registration inputs: The following inputs are used for cross-registration of hall calls.
• Cross reg - Down aux front input: Select floor in Association column.
• Cross reg - Down aux rear input: Select floor in Association column.
• Cross reg - Up aux front input: Select floor in Association column.
• Cross reg - Up aux rear input: Select floor in Association column.
• Cross reg - Down main front input: Select floor in Association column.
• Cross reg - Down main rear input: Select floor in Association column.
• Cross reg - Up main front input: Select floor in Association column.
• Cross reg - Up main rear input: Select floor in Association column.
• Cross reg - Car in-service input. Select Car ID in Association column.
• Cross registration outputs: Used for cross-registration of hall calls.
• Cross reg - Down aux front output: Select floor in Association column.
• Cross reg - Down aux rear output: Select floor in Association column.
• Cross reg - Up aux front output: Select floor in Association column.
• Cross reg - Up aux rear output: Select floor in Association column.
• Cross reg - Down main front output: Select floor in Association column.
• Cross reg - Down main rear output: Select floor in Association column.
• Cross reg - Up main front output: Select floor in Association column.
• Cross reg - Up main rear output: Select floor in Association column.
Note
For all the above, the floor selected in the Association column defines the call location for the
iCue software.
• Cross reg - Emergency dispatch output: (Notifies legacy group that we are unable to
cross-register hall calls because of a serial IO failure or iCue shutdown and that it
should put its cars on emergency dispatch operation.) Association column is blank.
Configuration Tabs - System I/O
10
10-55