Ibox Installation; Ibox File Upload - MCi iControl User Manual

iBox Installation

1. Verify that power is off at the main disconnect.
2. Open the iControl cabinet.
3. Remove the cover (bezel) from the new iBox.
4. Secure the new iBox in position between the rail-mounted circuit boards.
5. Slide the rail-mounted circuit boards above and below the iBox back into position so
that the central bus is plugged back in.
6. Tighten the board retaining screws.
7. Reconnect all cabling to the body of the iBox.

iBox File Upload

While online (connected to a controller, you may select a Configuration (.cfg) file and send all or
selected data from that file to the controller.
uration File" on page
Please refer to "Loading Parameters from a Config-
8-22.
Circuit Boards and Assemblies
6
6-81