Installation Instructions - MCi iControl User Manual

Installation Instructions

1. Attach the mounting pedestal securely to the elevator crosshead beam.
2. Place the iLand Compact on the mounting pedestal and slide it into position so that the
Position Encoder Wheel is touching the front face of the rail. If necessary, loosen the
screws that adjust the position of the Leveling Sensor Bracket(s) and slide the brackets
back away from the rail.
3. Move the base of the iLand Compact forward until the Parallel Arms are approximately
vertical and fasten it to the pedestal using four 1/2" (or 3/8") bolts, flat washers, lock
washers, and nuts.
Figure 3.
If necessary, loosen screws and slide the
Leveling Sensor Bracket(s) back
Position Encoder Wheel against the
front face of the rail
Nuts and lock washers
Installation Instructions
Parallel Arms vertical
Bolts and flat washers
3
3-5