MCi iControl User Manual page 444

Using iView
Table 8.8 System - Configuration Tabs
Tab Sub-Tab
Emergency
Power
System Building
Configuration
CFSS
Dispatching
Hall Call
Eligibility
Mode of
Operation
Parking
Parking
Eligibility
Split Bank
Legacy Group
Interface
Security General
Hall Calls
Car Calls
System I/O System
Bus
Timer Tables
User Events
Remote Outputs Configuration
Trigger
Table 8.9 System - Diagnostic Tabs
Tab
Event Log
Table 8.10 System - Miscellaneous Dialogs/Controls
Tab
Call Allows you to register car and hall calls. This control is accessed by clicking the Call
Registration Registration button on the button bar
Refresh Updates the information displayed on iView windows and tabs. This control is accessed
by clicking the Refresh button on the button bar.
8-32 Manual # 42-02-2222
Use to indicate cars connected to each generator and define how switch-
ing to and from emergency power is handled
Floor definition and labeling. Car definition and labeling
Definition of Commandeer For Special Services modes 1 and 2
(see page 10-9).
Define system dispatching options and manually select dispatching con-
figurations (see page
Define up to eight Hall call eligibility configurations
Define up to eight dispatching Mode of Operation configurations
page 10-14).
Define up to eight Parking configurations
Define up to eight Parking Eligibility configurations
This capability is only available through the Central Dispatcher
page 10-29).
Select either Cross-cancellation or Cross-registration
Shows the status of System Security. Use these controls to configure car
and hall call restrictions for a simplex or swing car or car assigned to be
the backup or local dispatcher for a group
Configuration of system input/output settings
Serial bus troubleshooting.
Use to configure timer tables to control system functions, e.g., Hall call
eligibility, Parking, Parking eligibility, Mode of operation, Security, and
User outputs 1 through 3
Define User Events which, when assigned a hardware input, are logged on
the System Event Log when activated and
Define and configure up to 32 Remote Outputs which can be wired to any
input or other device as needed
Display of recorded system events
Content
10-11)
(see page
(see page
(see page 10-62).
deactivated(see page
(see page 10-66).
Content
(page 10-68).
Content
(see page 10-73).
(see page 10-33).
(see page 10-7).
(see page 10-13).
(see
10-21).
(see page 10-27).
(see
(see page 10-36).
10-38).
(see page 10-51).
10-65).