MCi iControl User Manual page 459

• Independent Service: Independent service is usually initiated by a key-operated switch
inside the car to allow the elevator to be operated by an in-car Attendant. While on Inde-
pendent service, hall call buttons and lamps for the elevator are disabled. The elevator will
respond only to car calls that have been enabled via different settings as specified by the
car call eligibility and card reader options. Door operation is typically automatic open with
constant pressure on the door close button required to close the doors. However, user set-
tings are available to modify door operation if desired.
Independent Service Tab" on page 9-59.
• Inspection: One of the inspection modes (in-car, machine room or cartop) is active and the
car is operating in Inspection mode. The Inspection profile parameters are used.
• Machine Room Inspection: The car has been placed on Machine Room Inspection mode
using the iBox Inspection switch. (All other Inspection modes must be inactive before
Machine Room Inspection may be enabled.)
• Passenger: The car is operating in normal passenger mode, responding to dispatching and
parking instructions and to hall and car call demands. Car and door operation are deter-
mined by settings on the Configuration > Car Operation > Passenger tab.
"Car Operation - Passenger Tab" on page
• Sabbath Operation: The elevator is operating in Sabbath mode initiated by a software
command, switched input or timer. Sabbath mode allows the elevator to operate, serving
the building without requiring buttons to be pressed for hall calls or car calls. Car behavior
is determined by parameters located on the Configuration > Car Operation > Sabbath
operation tab. Please refer to "Car Operation - Sabbath Tab" on page
• Shuttle service: The elevator is operating in Shuttle service mode initiated by a key-switch/
input, software command or timer. This option allows the car to be used to provide
express service for a subset of the building's floors. Car behavior is determined by parame-
ters located on the Configuration > Car Operation > Shuttle service tab.
"Car Operation - Shuttle Service" on page
• Test: Indicates that the iBox Test switch is in the Test position and the elevator is in Test
mode, generally used to adjust or test the elevator. The elevator operates the same as in
normal passenger mode except that the doors are disabled and no hall calls are registered.
Controller View Windows and Tabs
Please refer to "Car Operation -
9-37.
9-84.
Please refer to
9-81.
Please refer to
9-7
9