MCi iControl User Manual page 326

Troubleshooting
Table 6.3 iControl Messages
Invalid Configuration Inventory Cross Check RGOPT, INV INVTRY XCHK RGOPT
Description: Rope Gripper Option. The safety system detected a configuration/inventory (board comple-
ment) difference when cross checking board complement against system configuration.
Car Reaction: Safety OK remains off.
Troubleshooting:
1. Verify that the Configuration settings on the Setup > Safety > Configuration tab match the car options/
wiring. Any emergency brake options require an emergency brake board be attached to the safety
expansion bus. Likewise, a emergency brake board attached to the safety expansion bus requires at
least one emergency brake option be selected on the Safety Configuration (Setup > Safety > Configura-
tion tab).
2. If the safety configuration is incorrect, make appropriate changes and re-learn the new configuration
using the Learn operation on the Setup > Safety > Configuration tab.
3. Re-learn the inventory of boards using the Inventory Learn procedure on the Setup > Safety > Inventory
tab.
4. Reset the fault (press the iBox FAULT RESET button)
Invalid Configuration Inventory Cross Check TALRQ, INV INVTRY XCHK TALRQ
Description: Top Access Landing Rear Qualifier. The safety system detected a configuration/inventory (board
complement) difference when cross checking board complement against system configuration.
Car Reaction: Safety OK remains off.
Troubleshooting:
1. Verify that the Configuration settings on the Setup > Safety > Configuration tab match the car options/
wiring. Any rear door options require a rear door board be attached to the safety expansion bus. Like-
wise, a rear door board attached to the safety expansion bus requires at least one rear door option be
selected on the Safety Configuration (Setup > Safety > Configuration tab).
2. If the safety configuration is incorrect, make appropriate changes and re-learn the new configuration
using the Learn operation on the Setup > Safety > Configuration tab.
3. Re-learn the inventory of boards using the Inventory Learn procedure on the Setup > Safety > Inventory
tab.
4. Reset the fault (press the iBox FAULT RESET button).
Invalid Destination, INVALID DESTINATION
Description: The car has been assigned to a destination floor that does not have an opening.
Car Reaction: Car ignores the demand.
Troubleshooting: Check the current mode of operation and check the corresponding recall floor and verify
that the floor is set to a floor with an opening.
Invalid Front Door Position, INVLD FRONT DOOR PSTN
Description: The front door inputs are in an invalid state (i.e.: doors open and closed at the same time).
Car Reaction: Car is taken out of service and doors will stall.
Troubleshooting:
1. Check all the front door inputs and wiring.
2. Related inputs:
FrontDoorCloseLimit: Low when the doors are fully closed
FrontDoorPositionMonitoring: High when the doors are fully closed
FrontDoorOpenLimit: Low when doors are fully open
FrontCarGate: High when doors are fully closed
Invalid Input (See: Invalid Configuration Input)
6-50 Manual # 42-02-2222
iControl Messages
.