MCi iControl User Manual page 351

Table 6.3 iControl Messages
TERMINAL LEARN ON
Description: This status message, on the iBox display, indicates that the system is prepared to learn the
speed and position values for the normal (UNT1-5/DNT1-5) and emergency (UETS/DETS) terminal switches.
Terminal Synchronization Fault, TERMINAL SYNC FAULT
Description: The system either did not receive edge position data from the cartop or the system did not
detect a floor position magnet where expected.
Car Reaction: The car stops after crossing the floor magnet at the top or bottom terminal landing and is not
allowed to move.
Troubleshooting:
1. Verify that the car was not moved after power was shut off.
2. Verify that the up/down normal terminal switch #5 opens at the appropriate location. When the up/down
switch opens, no LU or LD sensor should be active. Also, only one floor magnet should be encountered in
the direction of travel after the up/down switch opens.
3. Move the car past floors around the vicinity of the fault and verify the proper activation of the LU and LD
sensors.
4. Verify that the system is communicating with the cartop (no Cartop Communication Fault).
5. Verify that the absolute and cartop positions change by the same amount and same direction while mov-
ing the car.
6. Verify that the terminal magnet has not fallen off.
7. Check the clearance between the floor sensor board and the magnets. Sometimes this clearance will be
off just enough to make some magnets fail to register properly. Adjust the clearance if necessary.
8. Re-learn the floor heights.
9. The iLink, iLand or iBox may be faulty.
Test Mode, Test
Description: Indicates that the elevator is in the Test mode of operation. iBox Test switch in Test position.
Car Reaction: Door operation is disabled. This setting is used to adjust or test the elevator.
This Car Alternate Fire Sensor Recall, THIS CAR ALT FIRE
Description: Recall to the alternate fire floor due to active or latched smoke detector input(s) from the cars
hoistway or machine room.
Car Reaction: Car proceeds to the user-defined alternate fire recall floor. Once at the recall floor, door opera-
tion is according to the user-defined door operation under fire recall operation. The fire warning indicator
light will flash.
Troubleshooting:
1. If in error, inspect the sensors, inputs, and connections.
2. Related Inputs: This Car Alt Recall sensor inputs as shown on the job prints.
This Car Main Fire Sensor Recall, THIS CAR MAIN FIRE
Description: Recall to the main fire floor due to active or latched smoke detector input(s) from the cars hoist-
way or machine room.
Car Reaction: Car proceeds to the user-defined main fire recall floor. Once at the recall floor, door operation
is according to the user-defined door operation under fire recall operation. The fire warning indicator light will
flash.
Troubleshooting:
1. If in error, inspect the sensors, inputs, and connections.
2. Related Inputs: This Car Main Recall sensor inputs as shown on the job prints.
Unintended Motion Fault (see Safety A Unintended Motion Fault)
iControl Messages
iControl Messages
6-75
6