Configuring System I/O - MCi iControl User Manual

Configuring System I/O

This table allows you to define each input or output on the bus. These settings are pre-
defined at the factory according to the job survey and should not need to be
changed if connected as shown on your job prints.
• Node address: The addresses available on this bus.
• Input/Output: The type of input or output assigned to this address.
To assign an input or output to a node address:
1. Click in the Input / Output cell next to the desired node address.
2. Click the down arrow (right side of cell).
3. Double click an input or output from the list provided.
4. Click in the adjacent Association cell.
5. Click the desired selection.
6. Click Send to send the assignment to iControl.
The pre-defined inputs and outputs include:
• Hall Calls
• Hall call - Down aux front: Select floor in Association column.
• Hall call - Down aux rear: Select floor in Association column.
• Hall call - Up aux front: Select floor in Association column.
• Hall call - Up aux rear: Select floor in Association column.
• Hall call - Down main front: Select floor in Association column.
• Hall call - Down main rear: Select floor in Association column.
• Hall call - Up main front: Select floor in Association column.
• Hall call - Up main rear. Select floor in Association column.
• CFSS calls (Commandeer for Special Service)
• CFSS call - Mode 1 front: Select floor in Association column.
• CFSS call - Mode 1 rear: Select floor in Association column.
• CFSS call - Mode 2 front: Select floor in Association column.
• CFSS call - Mode 2 rear: Select floor in Association column.
• CFSS outputs (Commandeer For Special Service)
• CFSS - Mode 1 in-use output: When all cars that are available to accept CFSS Mode 1
calls (determined by "Maximum number of cars to operate on CFSS Mode 1 at the
same time" and each car's eligibility map) have already been assigned to CFSS Mode 1
operation or are out-of-service, this output becomes active indicating that any addi-
tional CFSS Mode 1 calls must wait for a car to become available. Association column is
blank.
• CFSS - Mode 2 in-use output: When all cars that are available to accept CFSS Mode 2
calls (determined by "Maximum number of cars to operate on CFSS Mode 2 at the
same time" and each car's eligibility map) have already been assigned to CFSS Mode 2
operation or are out-of-service, this output becomes active indicating that any addi-
tional CFSS Mode 2 calls must wait for a car to become available. Association column
is blank.
Configuration Tabs - System I/O
10
10-53