MCi iControl User Manual page 327

Table 6.3 iControl Messages
Invalid Rear Door Position, INVLD REAR DOOR PSTN
Description: The rear door inputs are in an invalid state (i.e., doors open and closed at the same time).
Car Reaction: Car is taken out of service and doors will stall.
Troubleshooting:
1. Check all the rear door inputs and wiring.
2. Related inputs:
RearDoorCloseLimit: Low when the doors are fully closed
RearDoorPositionMonitoring: High when the doors are fully closed
RearDoorOpenLimit: Low when doors are fully open
RearCarGate: High when doors are fully closed
IO Map Compare Fault, IO MAP COMPARE FAULT
Description: Safety A IO Map did not match Safety B IO Map.
Car Reaction: If running, car makes an emergency stop. Car is not allowed to run.
Troubleshooting:
1. Press the Fault Reset button to clear the fault.
2. If problem persists it is an indication that the iBox may need to be replaced. Consult MCE Technical Sup-
port for instructions.
IO Map Compare Fault Off (See: IO Map Compare Fault)
IO Map Compare Long Term Fault, IO MAP COMPARE LT FLT
Description: Safety A long term products did not match Safety B long term products for 1.2 seconds.
Car Reaction: If running, car makes an emergency stop. Car is not allowed to run.
Troubleshooting:
1. Press the Fault Reset button to clear the fault.
2. If problem persists it is an indication that the iBox may need to be replaced. Consult MCE Technical Sup-
port for instructions.
IO Map Toggle Compare Fault, IO MAP TOGLE COMP FLT
Description: The failure of a safety input was detected during the "input toggle test" (performed at the end of
each run). This test verifies the proper operation of safety system inputs that normally remain unchanged
during the course of elevator operation.
Car Reaction: Emergency stop: Motor contactor and brake contactor immediately dropped.
Troubleshooting:
1. Press the Fault Reset button to clear the fault.
2. If problem persists it is an indication that the iBox may need to be replaced. Consult MCE Technical Sup-
port for instructions.
IO Map Toggle Compare Fault Off (See: IO Map Toggle Compare Fault)
iView Logged Off. Passenger operation. A previously active iView connection to the controller has logged
off.
iView Logged On. Passenger operation. An iView user has logged on to the controller.
iView Lost Connection. An iView connection has been dropped.
iView Timed Out. An iView connection was inactive for a period of time beyond the idle timeout and has
been disconnected.
iControl Messages
iControl Messages
6-51
6