MCi iControl User Manual page 475

Scale
One typical modification you might want to make is to the scale of a display. For
example, if you wanted to change the scale of the Test point 2 vertical display (Y axis):
1. Right-click on the Test point 2 display scale and select edit.
2. Set the Minimum value for the scale (Min = zero in our example).
3. Set the Span, number of units to display (Span = one in our example).
4. Close the Plot Axis Editor dialog.
Zoom to Fit
Zoom to Fit is another very useful tool. If you are
monitoring two signals, and they diverge so that both are not visible,
use Zoom to Fit to instantly bring each back into view (vertical scale).
Conversely, if two signals are very close together in the display, use
Zoom to Fit to expand the display and see fine changes in the signal.
• Right-click on the scale display then select Zoom to Fit.
For the horizontal scale, Zoom to Fit resets the left margin to zero time and scales the display to
include total elapsed time at that point. In other words, if you are tracking a signal over time,
then want to see all its transitions since you began tracking, use Zoom to Fit on the (lower) hor-
izontal scale.
Diagnostics Tabs
9-23
9