MCi iControl User Manual page 556

iView - Controller View
The method of assigning inputs and outputs to terminals is the same for Serial COP boards as
for Multiple Input AC (MIAC) and Multiple Output Relay (MOR) boards. Select a particular sig-
nal from the column and drag it to the desired connector pin box. Except for car call button
inputs and lamp outputs (shown below), each input or output may be assigned to only a single
terminal on the Serial COP boards.
Terminal Configuration (CTP - SERIAL COP)
Caution
The Terminal Configuration dialog reassigns the signal assignments to circuit board pins in
controller SOFTWARE. You must also make the correct hard connections to avoid damage
or incorrect operation.
9-104 Manual # 42-02-2222