Table of Contents
Advertisement
Using the Installation Checklist
This checklist provides general instructions to help experienced personnel install an iControl
AC elevator controller. Should you need detailed information for any item on the checklist, refer
to the specific sections of the User Guide suggested.
Installation Checklist (page 1 of 3)
Review the "Safety Precautions" in the Preface of the User Guide, iControl with AC Drive
and
see "Before You Begin" on page 2-2.
Review the job prints. They are always the controlling document
Prints" on page
Review the machine room preparation guidelines
page
2-4).
Check the controller visually. Verify that nothing has been damaged or dislodged during
shipment.
Review the controller installation guidelines
page
2-9).
Open cable access holes in the areas indicated by the stickers. Ensure that no metal filings
get into the electronics
Review the typical connection locations
page 2-11
and
Ground all equipment according to the job prints and local code
ing" on page
Install the field wiring as shown on the job prints.
Check for shorts to ground
Verify the main line power wiring
Verify proper bus voltages
Install and verify the wiring to the hoist motor
21
and
see "Wiring the Hoist Motor to the Controller" on page
Verify the brake current resistance and install the brake wiring
rent Resistance" on page 2-22
Install the encoder / tachometer
page
2-24).
Verify the safety string wiring
27).
Install the temporary cartop inspection controls
ing" on page
Apply power and verify that the iBox is functioning
Connect / verify the iView PC connection
Verify the initial parameter settings
43).
Learn the safety configuration
Perform the automated drive setup procedure
page
2-48).
2-7).
(see "Cable Access" on page
see "iBox Field Connections" on page
2-14).
(see "Equipment Grounding" on page
(see "AC Voltage Verification and Wiring" on page
(see "Initial Controller Power Up" on page
and
see "Wiring the Brake" on page
(see "Velocity Encoder Installation and Wiring " on
(see "Basic Safety String and Associated Wiring" on page 2-
2-29).
(see "Learning the Safety Configuration" on page
(see "Machine Room Preparation" on
(see "Controller Cabinet Installation" on
2-10).
(see "Overview of Typical Connection Locations" on
11-7).
(see "Checking the Hoist Motor" on page 2-
(see "Temporary Cartop Inspection Wir-
(see "Applying Power" on page
(see "Connecting the iView PC" on page
(see "Verifying Initial Parameter Settings" on page 2-
(see "Automated Drive Setup Procedure" on
(see "About MCE Job
(see "Equipment Ground-
2-14).
2-19).
2-21).
(see "Verifying Brake Cur-
2-23).
2-29).
2-30).
2-46).
2-17).
Intro-7
Advertisement
Table of Contents
Troubleshooting
