MCi iControl User Manual page 406

iBox Front Panel Controls
Table 7.1 Car Menu Parameters
To set the IP Gateway 3:
Enter a gateway address for the #3 port. Please refer to "System, LAN, & 3=PC TCP/IP Addresses"
on page 7-9.
To set the IP Subnet Mask 3:
Enter a subnet mask address for the #3 port. Please refer to "System, LAN, & 3=PC TCP/IP
Addresses" on page 7-9.
View Event log accesses the event database maintained by the controller. This database lists mes-
sages by ID Number, ordered by time-of-occurrence. Additional data is also stored, e.g. Type,
Date, Time, Acknowledgement Status, and Event (name) for each event. A listing of iBox Event
Log ID Numbers and a cross-reference to iControl Messages and descriptions can be found in Sec-
tion 6 of this User Guide.
Messages " on page 6-4
To view the Event Log:
Press softkey (1) beneath the Car label, scroll down to View Event Log and press Enter. To view
event details, scroll to the desired event and press Enter. Scroll down to see all of the data,
including the event name.
The View/Register Calls dialog allows you to send transport commands to the controller.
To View/Register Calls:
Allows you to enter car and hall calls for Front or Rear Car Operating Panels.
This parameter sets the real time clock for the controller.
To set the Set Time/Date:
Enter the current time and date for use by the controller real time clock.
View Factory Data accesses serial number, date, and MAC address information for the controller.
This information is very useful should you ever have to contact MCE about your equipment.
MAC Addresses:
A six-byte, unique, identifying code used by LANs to positively identify communicating equipment.
This parameter allows you to view the MAC address for each of the three Ethernet ports.
Manufacturing Info:
View the controller serial number, revision, and ICE-IMP information.
Version Info provides version information for the software currently installed on your controller.
Version Info:
View the software version information for the controller and car top processors.
View and/or clear statistical data collected by the controller. The statistical data includes the odom-
eter, power-up cycles, front and rear door cycles, motion cycles, floor time, floor runs, inspection
runs, auto runs, and auto relevels.
7-8 Manual # 42-02-2222
Car Menu Parameters
View Event Log
Please refer to "Cross Reference: iBox Event Log ID Numbers to iControl
and see "iControl Messages" on page 6-13
View/Register Calls
Set Time/Date
View Factory Data
Version Info
View / Clear Statistics