MCi iControl User Manual page 569

• Earthquake Buzzer: Active when the car is on Earthquake operation (earthquake sen-
sor or counterweight derailment inputs active).
• Earthquake Light: Active when the car is on Earthquake operation (earthquake sensor
or counterweight derailment inputs active).
• Egress Floor Gong: This output will activate for 300 msec. when the car arrives at the
"egress" floor and opens the doors in response to a hall or car call. This output is used
to activate an audible indicator to inform visually impaired passengers that the eleva-
tor has arrived a the main egress floor of the building. The egress floor is selected on
the Configuration > Car Operation > Passenger tab.
• Emerg. Pwr. Car Selected to Recall: Active when this car is selected to lower the recall
floor on emergency power.
• Emerg. Pwr. Car Selected to Run: Active when this car is selected to run on emergency
power (see Configuration > Car Operation > Emergency power tab).
• Emergency Power Car Done Recall: Active when the car has completed the recall on
Emergency Power operation.
• Emergency Power Phase I (Simplex): Activated when the Emergency Power input is
activated and remains on until all cars have returned to the recall floor.
• Emergency Power Phase II (Simplex): Activated when all car have reached the recall
floor and remains on until normal power is reinstated.
• Emergency Power Priority Status: Activated when the car is on EMS phase 2, CFSS
phase 2 and Fire Service Phase II.
• Emergency Power Recall Complete: Activated when the car is on Emergency Power
and is at the recall floor with the doors fully open.
• Emergency Power Service (Simplex): Active when the car is on Emergency Power
(Emergency Power input active). Configure using Configuration > Car Operation >
Emergency power tab.
• EMS Car Buzzer: This output comes on when the EMS 1 or EMS2 hall switch is acti-
vated and turns off when the car reaches the EMS floor (phase 1 return). It is used to
activate an in-car audible buzzer to alert passengers that the car is being comman-
deered for Emergency Medical Service.
• EMS Car Light: This output comes on when the EMS 1 or EMS2 hall switch is activated
and stays on until the car returns to normal service. It is used to activate a visual indi-
cator to alert passengers that the car is on Emergency Medical Service.
• EMS Hall Light 1 (2): These respective outputs come on when the EMS1 (or 2) hall
switch is activated and turns off when the in-car switch is activated. It is used to acti-
vate a visual indicator to alert EMS personnel that the EMS1 or EMS2 signal has been
registered. EMS settings and configured on the iView Configuration > Car Operation >
EMS tab.
• Empty Car Output: This output is active when one or more of the following are true:
Empty Load Input = On, Car Not Empty Sensor Input = Off or the car weight is below
the Empty load threshold setting on the Configuration > Load Weigher tab.
• Empty Load: This output is active when the car weight from an analog load weigher is
below the Empty load threshold on the Configuration > Load Weigher tab or the dis-
crete Empty Load Input is On.
Configuration - I/O Boards
9
9-117