Car Calls - Passcodes - MCi iControl User Manual

iView - System View
• Sabbath: Calls generated as a result of the car being on Sabbath operation.
• COP buttons: Calls placed using COP buttons while the car is operating in one of the
following modes: Attendant Service, CFSS 1, CFSS2, Independent service, Test mode,
Shuttle service.
5. Click OK.
Active overrides are displayed as single letters, each corresponding to a mode:
• I = Independent • A=Attendant
• T=Test Mode

Car Calls - Passcodes

This screen allows you to set parameters that pertain to per-floor and passenger passcodes.
• Timeout between buttons: Passcodes are entered using car operating panel (COP)
buttons. When the passenger is entering a passcode, if more than the number of seconds
set here elapses between button presses, the passcode entry will time out.
• Passenger passcode length: Sets the length of the passenger passcodes. (It is recom-
mended that the passenger passcode length and floor passcode length be the same).
Car Calls - Passcodes - Floor
This tab allows you to assign per-floor car call enable passcodes (passcodes are entered using
COP buttons). To program a floor passcode
1. Select the Configuration (1 - 8).
10-48 Manual # 42-02-2222
• E=Emerg Dispatch
• 1=CFSS1 • 2=CFSS2
• S=Sabbath • R=Remote
• D=Auto Door
• O=OBD