MCi iControl User Manual page 490

iView - Controller View
Table 9.7 Nudging Operation Table
Nudging Option
None
None
None
Buzzer only
Buzzer only
Buzzer only
Reduced speed and torque
Reduced speed and torque
• Allow hall call button to reverse doors on a departing car: (Not implemented on this
screen) Please refer to the iCue > Group Configuration > Dispatching tab "Allow same
floor hall calls to reverse doors on a departing car" parameter.
• Allow direction arrow to reverse with doors open: If the car is at a destination floor and the
next demand is in the opposite direction of the last run, determines whether the direction
arrow is allowed to reverse while the elevator doors are open. Enable if the direction arrow
is allowed to reverse with the elevator doors open.
• Cancel calls at slow down: By default, when a answering a call, the call is canceled when
the car reaches door zone. This option specifies that calls are to be canceled when the car
begins slow down when approaching the floor.
• Car delayed timer (seconds) - If a car is delayed in satisfying a demand an amount of time
in excess of this timer setting, it will be taken out of hall call service. All calls remain regis-
tered. Hall calls are reassigned if the car is in a group.
• Car out of service timer (minutes) - This timer starts once the Car delayed timer (above)
expires. If the Car delayed condition persists for this amount of time, the car is taken out of
service and all calls are cancelled.
• Car fan and light timer (minutes): Set the number of minutes the car fan and light should
remain on when the car is parked before automatically shutting off. The fan and light will
become active again when the car responds to a demand.
Anti-Nuisance
operation, for example, a passenger intentionally interfering with elevator operations by unnec-
essarily selecting multiple stops, etc.
• Photo eye: All remaining car calls are canceled if the photo eye has not been activated and
the number of car call stops exceeds the "Allowed number of car call stops without photo
eye activation" parameter.
• Light load: All car calls are canceled if the number of registered calls exceeds the "Number
of car calls allowed" parameter and the car weight (percentage of full load), as measured
by the load weigher, is less than the "Light Load Threshold" parameter.
• Cancel car calls behind car: If enabled, car calls entered in the opposite direction to cur-
rent or upcoming direction of travel are not allowed.
• Cancel remaining car calls with direction reversal: If enabled, when the car reverses direc-
tion of travel, any remaining calls in the previous direction are cancelled. For example, an
up travelling car has car calls registered below it. Those calls will be cancelled when the car
switches direction to down.
9-38 Manual # 42-02-2222
Bypass Safe Edge
Option Option
No -
Yes No
Yes Yes
No -
Yes No
Yes Yes
No -
Yes -
Anti-nuisance functions help the controller recognize and avoid nuisance
Nudge Buzzer Door Operation After
Output Output
Off Off Remain open
Off Off Remain open
Off Off Close at normal speed
Off On Remain open
Off On Remain open
Off On Close at normal speed
Off Off Remain open
On On Close at reduced speed
Device Timeout