MCi iControl User Manual page 338

Troubleshooting
Table 6.3 iControl Messages
Rear Photo Eye Bypassed, REAR PHOTO EYE BYP
Description: The rear photo eye device has been continuously activated for a user-defined time and is now
bypassed in accordance to the user-defined setting. (iView/Car Operation/Passenger/Anti Nuisance.)
Car Reaction: The rear photo eye device is rendered inoperative.
Troubleshooting:
1. To restore the operation of the photo eye device, check the corresponding input.
2. Related inputs:
PhotoEyeRear: Normally low
Rear Photo Eye Failure, REAR PHOTO EYE FAIL
Description: This event is logged when the photo eye is continuously activated for a predetermined time (4
seconds) while the rear doors are fully closed.
Car Reaction: The rear photo eye is rendered inoperative.
Troubleshooting:
1. Check for abnormal blockage or failure of the rear optical device.
2. Related inputs:
RearPhotoEye: Normally low
Rear Safe Edge Bypassed, REAR SAFE EDGE BYP
Description: The rear door safe edge has been continuously activated for a user-defined time and is now
bypassed according to the user-defined setting. (iView/Car Operation/Common/Door Device Bypass Timers.)
Car Reaction: The rear safe edge is rendered inoperative.
Troubleshooting:
1. Check the state of the rear safe edge input.
2. Related inputs:
SafeEdgeRear: Normally low
Rear Safe Edge Failure, REAR SAFE EDGE FAIL
Description: This event is logged when the rear door safe edge is continuously activated for a predetermined
time (4 seconds) while the rear doors are fully closed.
Car Reaction: The rear door safe edge is rendered inoperative.
Troubleshooting:
1. Check for abnormal blockage or failure of the rear door mechanical reopening device.
2. Related inputs:
RearSafeEdge: Normally low
Receive Sys Params
Description: Indicates that this controller is receiving system parameters from the Central or Local / Dis-
patcher. (DO NOT RESET THE CONTROLLER).
Restricted, RESTRICTED
Description: Indicates that this controller has been shipped with Restricted Mode enabled. The controller will
run in all modes of operation, but will not accept hall call assignments. Restricted mode can be terminated at
any time by entering the Restricted Mode Key as described in document 42-IS-0144, Restricted Mode
Instruction for iControl Users. Obtain the Restricted Mode Key by calling MCE's Credit Department at (916)
463-9582. When calling, please provide the controller's job number and car identifier.
R DR CLS FLT REC FAIL. See Rear Door Close Fault Recovery Failure
6-62 Manual # 42-02-2222
iControl Messages