MCi iControl User Manual page 553

Using the I/O Board Configuration Tab
inputs and outputs, should you desire to make changes.
To add a board:
1. Select IMP / CTP or COP 1 - 4. Note: COP4 is not available on Cartop software version
1.1.15 of greater.
2. Locate the board in the Boards box on the right of the Configuration tab.
3. Drag the board into the ICE-IMP (iControl), ICE-CTP (iLink cartop box) or COP 1 - 4
(Car Operating Panel) enclosure as appropriate. Release the mouse button.
4. To rearrange a board along the bus representation, highlight it and click on the associ-
ated up/down controls. The board will move accordingly.
5. To remove a board, select and click Delete.
To change the input or output to/from a board connection:
1. Click to select the desired board and click Edit.
2. Select a signal group from the drop down list in the Signals box.
3. Select a signal from the list and drag it to the desired pin in the Terminals box.
4. To remove a signal from a pin, drag it into the trash or right click and then click Remove
signal. To remove all signal assignments, click the Clear all button.
5. Click OK to approve your configuration.
6. Click Send to send your changes to the controller.
7. Or, click Cancel to close the dialog without saving any changes.
Each input or output may be assigned to only a single terminal.
Terminal Configuration (IMP - MIAC)
Configuration - I/O Boards
This tab is used to program I/O Board
9
9-101