MCi iControl User Manual page 438

Using iView
Specific contents will vary depending on the hardware installed at your site and on the revision
level of your iView and iBox software. Always refer first to the online help available within
iView. Online help contains the most detailed and current information about your iView soft-
ware. For detailed parameter or display descriptions, refer also to
Table 5.2 lists the items on the View menu and tables 5.3 through 5.5 list the tabs found on the
Configuration, Diagnostics and Setup menus. Click the "see page" links to jump to that page.
Table 8.2 Controller - View Menu
Window
Configuration
Diagnostics
Setup
Hoistway
Safety Tests
Layouts
Table 8.3 Controller - Configuration Tabs
Tab Sub-Tab
Advanced Custom
Outputs
User Events
Brake Control
Configuration
Car Call Enable
Car Operation Doors
(see page 9-29)
Devices
Passenger
8-26 Manual # 42-02-2222
Parameter settings are displayed and may be changed on the Configuration tabs.
The tabs include Brake, Car Operation, Drive, General, I/O Board, Load Weigher,
Motor Field, Pattern, Safety, Serial I/O Simplex Configuration, Simplex Security,
Terminal Switches and Timer Tables
The Diagnostic tabs contain information about the status and condition of the con-
troller. The tabs include Diagnostic Outputs, Event Log, Fault Bypass, Operational
Status and Terminal Switches Status. Three additional diagnostic screens, Data
Trap, Diagnostic Outputs and Virtual Oscilloscope, are displayed each in their own
window. This allows them to be used with other windows
The Setup tabs are used to perform the automatic and semi-automatic setup pro-
cedures. The tabs include Brake, Counterweight, Drive, Floor Heights, Floor Off-
sets, Load Weigher, Safety and Terminal Switches
A graphical representation of the car in the hoistway, including assigned car and
hall calls. Shows the current mode of operation, direction preference, speed and
actual floor height information
Automated control of acceptance test procedures
Pre-programmed screen layouts can be displayed. Custom screen layouts can be
created and saved and displayed
Allows existing inputs, outputs and internal flags to be combined in a logic
equation which can then generate a custom output
Configure User Events
Brake voltage, timer and filter settings
Brake voltage, Output timer, and Current reference settings for braking
progression at 10% increments (brake fine tuning)
Configure the enable inputs to be active high or low
Door motor protection timer settings, safe edge and photo eye bypass
selections, plus front and rear door closing delay, etc.
Hall and car gong settings, emergency alarm monitoring and serial fixture
parameters (see page
Anti-nuisance, nudging, exercise operation, automatic swing operation,
and door operation settings for car in normal passenger service
(see page 9-37).
Section 9
Content
(see page 9-24).
(see page
(see page 9-4).
(see page
(see page 9-153).
Content
(see page 9-138)
(see page
9-33).
of this manual.
(see page 9-11).
9-140).
9-152).
(see page 9-139).
9-25).
(see page 9-27).
(see page 9-28).
(see page 9-30).