Section 3. Inspection Mode; In This Section - MCi iControl User Manual

In This Section

This section provides the information you need to complete all field wiring and pre-
pare the elevator to operate in Inspection Mode, including:
• iLand Landing System Installation
• iLink Interconnect Installation
• Hoistway Limit Switches
• Load Weigher Installation
• Brake Monitoring
• Earthquake Sensor
• Serial Hall Call (see
• Serial COP (see page
• Cartop Voltage Verification
• Door Operation (see
• Running on Machine Room Inspection Mode
• Preparing for Final Adjustments
Caution
Instructions in this section assume you have completed all Construction Mode instructions
in the previous section and that the elevator car is running safely and reliably in Construc-
tion Mode. Note that, in the course of installing the iLink cartop box, YOU MUST UNDO the
temporary cartop CTS bypass used to run the car on Construction Mode (with no iLink car-
top box installed).
Inspection Mode
(see page
(see page 3-19).
(see page 3-20).
(see page 3-21).
page 3-22).
3-22).
(see page 3-23).
page 3-24).
(see page
• In this Section
• iLand Installation
• iLink Installation
• Hoistway Switches
• Load Weigher
• Brake Monitoring
• Earthquake Sensor
• Serial Hall Call
• Serial COP
• Voltage Verification
• Door Operation
• Inspection Mode
• Prep for Final Adjust
(see page 3-2).
(see page 3-13).
3-19).
(see page 3-26).
3-28).
3
3-1