Table of Contents
Advertisement
In This Section
This section provides the information you need to install iControl and get the eleva-
tor running in Construction Mode:
• Machine Room Preparation (see page 2-4).
• Recommended Tools and Test Equipment (see page 2-6).
• About MCE Job Prints (see page 2-7).
• Controller Cabinet Installation (see page 2-9).
• Equipment Grounding (see page 2-14).
• Check for Shorts to Ground (see page 2-16).
• AC Voltage Verification and Wiring (see page 2-17).
• Motor and Brake Wiring (see page 2-21).
• Velocity Encoder Installation (see page 2-24).
• Safety String Wiring (see page 2-27).
• Applying Power (see page 2-29).
• LAN Connections (see page 2-32).
• Initial Parameter Settings (see page 2-43).
• Drive Parameter Adjustments (see page 2-47).
• Brake Calibration (see page 2-50).
• Running on Machine Room Inspection (see page 2-54).
• Calibration Actual Car Speed (see page 2-57).
Construction Mode
• In this Section
• Machine Room Prep
• Recommended Tools
• MCE Job Prints
• Cabinet Installation
• Equipment Grounding
• Check for Shorts
• AC Voltage
• Motor, Brake, Encoder
• Safety String
• Applying Power
• Initial Parameters
• Brake Calibration
• Running on Inspection
2
2-1
Advertisement
Table of Contents
Troubleshooting
