MCi iControl User Manual page 716

Reference
Table 11.6 TORQMAX F5 Drive Parameters Quick Reference for iControl AC
Brake drop delay: Time motor will hold full current
LF.78
and control after direction inputs drop.
Current hold time: Delay in turning off the drive
LF.79 (Delay to turn OFF the motor current after the
direction is dropped and LF.78 has expired)
LF.25 Estimated gear ratio
LF.80 Software version
LF.81 Software date
LF.82 X2A-input state
LF.83 X2A-output state
LF.86 Operational mode
LF.87 Actual inverter load (100% = rated load)
LF.88 Motor command speed
LF.89 Actual motor speed
LF.90 Actual elevator speed
LF.93 Phase current
LF.94 Peak phase current
LF.95 Actual DC voltage
LF.96 Peak DC Voltage
LF.97 Actual output frequency
O.LF.98 Last error
Password: With different passwords, different
US. 1 parameter groups can be accessed for advanced
programming.
Load defaults. Select LoAd and press ENTER to
US. 3 cause all LF parameters to be reset to drive default
values.
Load configuration. Select LoAd and press ENTER
US. 4
to load the configuration selected in US.10.
Select Configuration. User selection of drive mode.
I CLSd = Induction motor (closed loop)
I 9LSS = Induction motor (closed loop) gearless
US.10
P CLSd = Synchronous motor (closed loop)
P 9LSS = Synchronous motor (closed loop)gearless
Loaded using parameter US.04.
* Parameters are motor/machine/job dependent.
** Recommended but field adjustable.
*** The value is automatically calculated from the motor data or other parameter values.
****Parameters apply to Drive Software Version 1.71 or greater)
Parameters for Drive Software Version (LF.80 = 1.61 or greater), Software date (LF.81 = 2801.9 or later)
Job #:
Prod. Order #:
Drive Model #:
11-30 Manual # 42-02-2222
Diagnostic Parameters (Read only)
US - Parameters
Drive Serial #:
Test technician:
Date:
sec 0.0-3.00 0.50
0.300 -
sec 0.300
3.000
1
MMDD.Y
see tables in
F5 Drive
Manual
%
rpm
rpm
ft/m
A
A
V
V
Hz
- 0-9999
- LoAd
- LoAd
ICLSd
I 9LSS
-
P CLSd
P 9LSS
0.50
0.30 - 0.80
- -
- -
- -
*
-
_________