MCi iControl User Manual page 660

iView - System View
• Enter the Pass Code by clicking the desired call buttons and front or rear
• Modes Allowed: Authorizes the passenger to use the COP passcode while the car is oper-
ating on the selected mode(s) in addition to Passenger mode.
Security - COP Passcode operation
passcode to register call a call to a secured floor works as follows:
1. Press a floor selection on the COP as usual. The panel buttons will flash to indicate that a
passcode must be entered.
2. Press floor buttons to enter the passcode.
3. Correct entry of the passcode will register the call. The panel buttons will return to nor-
mal.
• An incorrect or timed-out entry will not register the call. The user may repeat the pro-
cess if the entry was incorrect or timed out.
Note
If both a passcode entry and an enable input (card reader or switch) are required to register a
particular call, the enable input must be completed before the COP passcode is entered.
10-50 Manual # 42-02-2222
For the elevator passenger, using the COP