MCi iControl User Manual page 458

iView - Controller View
• Construction Hoistway Access Inspection: Construction mode is enabled (Configuration >
Safety tab), and the hall mounted Access switch has been activated. However, while in
Construction mode, the hoistway access inspection switches are ignored. The car can only
be operated via the machine room or cartop inspection switches while in Construction
mode. Place the car on machine room or cartop inspection and operate the car with the
appropriate switches.
• Construction Inspection: Construction mode is enabled (Configuration > Safety tab),
allowing the car to be run on Inspection with a bare minimum of field wiring installed, and
the car is therefor operating on Inspection operation. The car can be moved using either
the cartop or machine room inspection operation switches.
• Construction Machine Room Inspection: Construction mode is enabled (Configuration >
Safety tab), allowing the car to be run on Inspection with a bare minimum of field wiring
installed, and the iBox INSPECTION switch has been placed in the INSP position. Use the
iBox Up, Down and Enable switches to move the car.
• EMS In-car (Switch 1 / 2): Emergency Medical Service - The EMS in-car switch has been
activated. The car remains on EMS operation until it is returned to the recall floor and the
in-car switch is deactivated.
• EMS Recall (Switch 1 / 2): Emergency Medical Service has been activated via a hall switch
(1 or 2). Car behavior, including the designated recall floor, are determined by the General
settings on the Configuration > Car Operation > EMS > Switch 1 (2) tab.
"Car Operation - EMS Tab" on page
• Fire Service In-car: In-car Firefighter's Service has been activated via the in-car fire service
key-switch. Car and door behavior is determined by the fire code settings on the Configu-
ration > Car Operation > Fire service > Fire code > In-car tab.
In-Car - General Tab" on page
• Fire Service Recall Alternate: Fire Recall Operation (Phase I), to the alternate fire recall
floor has been initiated. Generally this is initiated by the activation of a smoke detector at
the main fire recall floor. The car proceeds to the alternate fire recall floor designated on
the Configuration > Car Operation > Fire service tab. Car and door behavior is determined
by the fire code settings on the Configuration > Car Operation > Fire service > Fire code >
Recall tab.
• Fire Service Recall Main: Fire Recall Operation (Phase I), at the main fire recall floor, has
been initiated. Generally this is initiated by the activation of a smoke detector on a floor
other than the main fire recall floor. Can also be initiated by the activation of the fire recall
switch input. The car proceeds to the main fire recall floor designated on the Configuration
> Car Operation > Fire service tab. Car and door behavior is determined by the fire code
settings on the Configuration > Car Operation > Fire service > Fire code > Recall tab.
Please refer to "Fire Code - Recall - General Tab" on page 9-47.
• Hoistway Access: The car has been placed on Hoistway Access Inspection mode using one
of the hall panel mounted switches. The car can be positioned to allow access to the cartop
or bottom.
9-6 Manual # 42-02-2222
9-52.
Please refer to "Fire Code - Recall - General Tab" on page
9-66.
Please refer to
Please refer to "Fire Code -
9-47.