MCi iControl User Manual page 318

Troubleshooting
Table 6.3 iControl Messages
Hall Call Service Enabled (see Hall Call Service Disabled)
Description: The car is accepting hall calls (iBox IN GROUP indicator is On). See also, Hall Call Service Dis-
abled.
Heat Detectors Recall Activated, HEAT DETECTORS RECALL
Description: A heat detector input has been activated.
Car Reaction: A car that is parked at a floor will open its doors and shut down. A car in motion will proceed in
the current direction to the next available floor where the heat detector is not tripped. If all heat detectors in
the current direction are tripped, the car will reverse direction and proceed to the first floor where the heat
detector is not tripped. If again all heat detectors are tripped, the car shall proceed to the main fire recall
floor unless the car is also on Fire Service, in which case the car will proceed to the appropriate fire recall
floor. Once the car is stopped at a floor it shall automatically open its doors and shut down. Then, if the
machine room or hoistway heat detectors are active, a signal is provided to disconnect the main power line
and activate the sprinklers where available.
Heat Detectors Recall Complete
Description: Indicates that the car has completed the Heat Detectors Recall operation (reached a floor and
doors are fully open).
Car Reaction: The car remains shut down until all heat detector inputs have been deactivated (see Heat
Detectors Recall Deactivated).
Heat Detectors Recall Deactivated
Description: All heat detector inputs are deactivated
Car Reaction: The car is allowed to run.
Heat Sensor Fault 'n' (n = 2 to 4)
Description: Not currently used.
Hoistway Access Disabled, HA INSP. DISABLED
Description: Hoistway access inspection operation has been disabled.
Car Reaction: The car cannot be run on hoistway access inspection operation.
Troubleshooting:
1. Check for any car status that might prevent hoistway access inspection operation, e.g. earthquake.
2. Check for the Stuck Inspection Input Fault.
3. Check all inspection buttons (Enable, Up, Down) and verify that none are stuck in the ON position.
Hoistway Access Enabled
Description: Hoistway access inspection operation which was previously disabled is now enabled.
Hoistway Access Inspection Operation, Hoistway Access Operation, Hoistway Access
Description: Car is on Hoistway access (enabled by the Hoistway access switch).
Car Reaction: If running, the car will make an emergency stop and is taken out of normal service. Under this
mode of operation, car can only be moved manually using the access key switches.
Troubleshooting:
1. Related inputs:
HoistwayAccess: Normally high
Hoistway Door Bypass, HOISTWAY DOOR BYPASS
The Hoistway Door Bypass switch on the iBox is in the Bypass position. (View-only on iView Safety screen,
enabled/disabled by MCE according to safety jurisdiction.) The ability to set this bypass must be enabled at
the factory and is only available if allowed by safety regulations in your area. Check the iView Safety Config-
uration screen to see if the feature is enabled in your installation.
Description:
Car Reaction: The car is placed in Inspection mode. To move the car, you must place it in either cartop or
car panel inspection mode. No other modes of operation are allowed.
6-42 Manual # 42-02-2222
iControl Messages
Please refer to "Car Operation - Heat Detectors" on page 9-86.