iView - Controller View
Controller - Setup Tabs
The Setup tabs allow you to perform various setup and calibration procedures. Typically these
procedures require observation or manipulation of parameters contained on the associated
Configuration tab. Screen layouts have been created that display both the configuration and the
setup tab. Therefore, when performing a setup procedure, it is recommend to use the layout dis-
play, e.g. when performing the Brake Calibration, use the Brake layout (View > Layouts >
Brake).
Setup - Brake Tab
The Setup > Brake tab allows you to perform the brake calibration procedure. When performing
this procedure it is recommend to display the Brake Layout (View > Layout > Brake)
• Indicators: The Calibrating, Waiting, and progress indicators track and report progress
through Brake Calibration phases.
• Message window: Provides feedback and instructions during Brake Calibration.
• Default button: Sets brake parameters to the default values.
• Calibrate button: Starts the Brake Calibration procedure using voltage and timer values
entered.
• Abort button: Aborts the Brake Calibration procedure.
• Continue button: Restarts the Brake Calibration procedure if it has paused to allow com-
pletion of an instruction displayed in the message window.
The brake calibration procedure is described in Section 2 of this manual.
Offsets Calibration" on page
9-140 Manual # 42-02-2222
2-48.
Please refer to "Drive