MCi iControl User Manual page 24

Clear Event Log
cleared using the Clear all button on the event log's button bar.
Data Trap
output states, internal flags and parameter values
152).
Hoistway Access Recall
been added to allow the activation of a hoistway access switch/input to also recall the car
"Hoistway Access Recall" on page
Shuttle Service
for a subset of the building's floors. For more information
on page 9-84.
I/O Assertion
terminal on an I/O board and assert a desired state (on or off) via iView
page 9-102).
System I/O for Simplex and Swing Cars
plied to the dispatcher via the Serial Hall Call system are now available on the MIAC and MOR
boards.
Controller - User Events
Input / Event Names can be programmed. This event name can then be assigned to a hardware
input. An event is logged, on the Controller Event Log, when the input is activated and again
when it is deactivated
Controller - Custom Outputs
existing controller inputs, outputs and internal flags to be used in custom logic equations which
can then generate controller outputs
page 9-139).
Rope Tension Load Weigher
tension of the wire ropes, is now available for use with iControl
Installation and Calibration" on page
Default Configuration File
can be saved to a configuration (.cfg) file. The default parameter values can then be loaded onto
the controller (see "Saving Parameters to a Configuration File" on page
Brake Contact Input
tact input to be set to either active high or low
TAPS Interface
use the new Traction Auxiliary Power Supply (TAPS)
Tab" on page 9-70).
Serial Drive Control
speed commands and receive speed feedback from the AC drive via a serial link.
Intro-4 Manual # 42-02-2222 B6, July 2010
The data stored in the event logs, controller and system, can be easily
This diagnostic tool automatically records controller data including input and
To facilitate ease of gaining hoistway access, controls have
9-63).
The Shuttle Service option allows a local car to provide express service
This troubleshooting tool allows the user to bypass the current state of a
Users can assign a name to an Input / User Event. Up to 10
(see "Configuration - Advanced - User Events" on page
(see "Configuration - Advanced - Custom Outputs" on
5-53).
The Controller and/or System default parameter settings
Controls have been added to allow the polarity of the brake con-
Controls and logic have been added to allow iControl with AC Drive to
An option has been added to allow iControl to communicate
(see "Controller - Safety Tests" on page 9-
see "Car Operation - Shuttle Service"
The inputs and outputs normally sup-
Custom Outputs is an advanced feature that allows
An additional load weighing option, which measures
(see "Brake - Control Tab - Switch" on page
(see "Car Operation - Emergency Power
(see "I/O Assert" on
9-138).
(see "EMCO Load Weigher
8-20).
(see
9-25).