MCi iControl User Manual page 29

Verify proper one-floor run operation
3).
Verify proper releveling
Verify proper speed pick delay and pattern scaling
at Contract Speed" on page
Learn the terminal slowdown and limit switches
minal Limit Switches" on page
Fine tune the TORQMAX drive
Verify the pattern parameter settings with regard to contract speed overshoot and current
limiting, the slope of acceleration and deceleration, final approach to the floor, excessive
motor noise and bunching up of deceleration rate
page 4-14).
Verify the parameter settings that control the initial start of car motion, e.g. load weigher
sensor and pretorque gain adjustments and motor control and brake parameter adjust-
ments (see "Controlling Initial Start of Car Motion" on page
Calibrate the floor offsets
Verify the parameter settings related to final approach, leveling, final stop and releveling
(see "Adjusting Leveling and Final Stop" on page
Verify the load weigher adjustments for dispatching and load weigher configuration, if
applicable (see "Load Weigher Adjustment for Dispatching" on page 4-30
Weigher Configuration" on page
Verify the pre-start sequence parameters, if applicable
35).
Verify the parameter settings relating to tach error tripping threshold and armature over-
current overload protection
page 4-41).
Perform the safety tests
Verify that no safety function or circuit remains bypassed prior to releasing the car for nor-
mal passenger operation
(see "Verifying One Floor Run Operation" on page 4-
(see "Verify Releveling" on page
4-7).
4-9)
(see "Fine Tuning the TORQMAX Drive" on page
(see "Calibrating the Floor Offsets" on page
4-32).
(see "Calibration and Verification of Safety Functions" on
(see "Safety Tests" on page
(see "Before Release to Passenger Operation" on page
4-6).
(see "Final Adjustment Before Running
(see "Learning Normal & Emergency Ter-
(see "Setting Pattern Parameters" on
4-16).
4-23).
4-26).
(see "Pre-Start Sequence" on page 4-
4-43).
4-11).
and see "Load
4-57).
Intro-9