MCi iControl User Manual page 271

Figure 5.4 Target Bracket and Sensor mounted on Support Assembly and Car frame
These screws hold the 2 small
angles to the bottom of the floor -
minimum 2 screws per angle.
Screws must be short enough to
avoid punching through the floor.
Support Assy
2 short pieces of
angle and 1 long
piece of angle
Note
The position sensed is where the support assembly for the target bracket is attached to the floor,
NOT where the sensor is located.
Center of Floor
Center of Gravity
FLOOR
Target
Bracket
(2 pieces)
Adjustment bolts
for setting 1/16"
clearance between
Maintain a 1/4" space between target
sensor and target
bracket and channels
bracket
MCE Load Weigher
Front of car
Conduit to iLink
Proximity sensor
Sensor bracket
5-65
5