About Mce Job Prints - MCi iControl User Manual

About MCE Job Prints

MCE Job Prints are technical drawing and instruction sets specifically generated for and
accompanying each MCE installation. The job prints provide technical information and instruc-
tion specific to the installation using the survey information collected when the job was speci-
fied and initiated. Job prints are frequently referenced by installation instructions and are a
critical resource for elevator installation and maintenance technicians.
Become familiar with the following information as well as the wiring prints provided with this
control system.
Drawing Number Format - Each
print has a drawing number in
the title block. The drawing num-
ber contains the job number, car
number and page number (see
examples). In this manual the
drawings will often be referred to
by the last digit of the drawing
number (page number).
Note
Drawing Name: Some drawings have a drawing name directly above the title block or at the top
of the drawing. The drawing name may also be used to refer to a particular drawing.
MCE job print drawing numbers use the format "Job Number — Car Number — Drawing Iden-
tifier." Thus they are specifically "keyed" to particular installations. It makes using and under-
standing job prints much easier if you take some time to review the job prints package before
beginning controller installation. Drawing identifiers and the information you can expect to
find on that job print drawing are listed below:
• N: Nomenclature drawing — schematic symbols, wire gauge information, circuit board
names and symbols.
• INT: iLink cartop wiring interconnect box to controller connections.
• CVR: iBox controls and indicators.
• 1: AC power connections, power bus information.
• 2 through nn: iBox/controller wiring.
• CC: Contact Count drawing — System contact/relay information.
• SH: Serial Hall Call wiring.
• CT: Cartop wiring (iLink cartop wiring interconnect box).
• COP: Car Operating Panel to cartop box (iLink) wiring.
• CW: Car to cartop box (iLink) wiring.
• MRW1, -MRW2: Machine Room and Hoistway wiring.
• D1, -D2, -D3, -D4: Controller and drive wiring.
Job Number
2003012345-2-1
* Car Number "G" = Group Controller
** Page Number "D" = Drive Page, CT= iLink
** An "X" after the page number = auxiliary page
About MCE Job Prints
Car Number*
Page Number**
2
2-7