MCi iControl User Manual page 572

iView - Controller View
tabs. Automatic swing operation is enabled on the Configuration > Car Operation >
Passenger tab. Car call eligibility is set on the Configuration > General > Car call eligi-
bility tab.
• Test Mode: Active when the car is on Test mode operation.
• Front Door — Rear Door
• Front (Rear) Car Gong: This output is activated to announce the elevator's intention to
go up or down after the car steps into a floor by sounding the front or rear car gong.
Timer options located on Configuration > Car Operation > Devices tab.
• Front (Rear) Closing Warning Buzzer: This output is active, before automatic closing
of the front or rear doors, for the length of time indicated by the "Door closing delay
timer" on the Configuration > Car Operation > Doors > Front or Rear tab. The door
close warning buzzer is required for power operated vertically sliding doors whenever
they are closed automatically or with momentary pressure. It must come on at least 5
seconds prior to the start of closing and stays on until the front/rear doors are closed.
For momentary pressure closing, when the in-car front/rear door close button is
pressed, the 5 second closing delay may be omitted.
• Front (Rear) Disable Automatic Close: Used to disable automatic closing, these out-
puts are normally OFF and can be configured, on the Configuration > I/O Board >
Configurable outputs tab, to turn ON during any combination of the following modes/
conditions: In-car fire service, Independent service, Attendant service, In-car CFSS
mode 1 (2) operation, In-car EMS operation, Door hold button or timer activation.
• Front (Rear) Disable Hall Door Buttons: Used to disable the hall door buttons station,
this output is normally OFF and can be configured, on the Configuration > I/O Board
> Configurable outputs tab, to turn ON during any combination of the following modes
and/or conditions: In-car fire service, Independent service, Attendant service, In-car
CFSS mode 1 (2) operation, In-car EMS operation, Door hold button or timer activa-
tion.
• Front (Rear) Door Close Limit: Inactive when the doors are fully closed.
• Front (Rear) Door Enable: Used to cut power to front/rear doors, these outputs are
normally ON and can be configured, on the Configuration > I/O Board > Configurable
outputs tab, to turn OFF during any combination of the following modes and/or condi-
tions: Test mode, Inspection operation, In-car stop switch activated and doors are fully
open, Door stop input activated.
• Front (Rear) Door Hold End: This output turns on five seconds prior to expiration of
the "Door hold" timer (see Front (Rear) Door Hold Function).
• Front (Rear) Door Hold Function: This output is active during the time the doors are
being held by the "Door hold" timer (Configuration > Car Operation > Passenger >
Door Operation - Door Dwell Timers).
• Front (Rear) Door Left Open: This output is used for non-automatic front/rear doors
and shall be ON if the front/rear doors are open and a hall call button is pressed. Oth-
erwise it shall be OFF.
• Front (Rear) Door Lock Power: This output is activated when the doors are closed and
locked and is used for door operators that need a separate signal to hold the doors
closed.
• Front (Rear) Down Car Lantern: This output is activated (usually a double ding: on-
off-on) to announce the elevator's intention to go down after the doors start to open by
operating the front or rear in-car gong/lantern assembly. This will happen when a
9-120 Manual # 42-02-2222