Prepare For Final Adjustments; Door Operator; Counterweight Learn Procedure - MCi iControl User Manual

Inspection Mode

Prepare for Final Adjustments

This section describes preparing for final adjustment.

Door Operator

The door operator must be working properly before final adjustment.
1. Verify that the door fuses are properly installed.
2. Verify that the iBox Car Door Bypass and Hoistway Door Bypass switches are OFF.
3. Check that all door equipment clutches, rollers, etc. are properly adjusted to correct run-
ning clearances.
4. Check the controller prints to make sure any door operator diode installation instruc-
tions have been followed (especially for G.A.L. door operators).
5. Verify that all hoistway and car doors are closed and locked.
6. Run the car through the hoistway on inspection mode to make sure the hoistway is com-
pletely clear.

Counterweight Learn Procedure

This procedure allows the controller to learn the hoistway position at which the car and coun-
terweight are at the same height. It must be performed if the controller will be using Earthquake
operation, and it is helpful for counterweight balancing and pre-torque gain adjustment.
1. Move the car until the car and the counterweight are at the same height in the hoistway.
2. Place the iBox Inspection switch in the INSP position.
3. Place the iBox Learn switch in the ON position.
4. Display the Counterweight setup tab (View > Setup > Counterweight).
5. If Not ready is lighted, follow the instructions in the message window until Ready is
lighted.
6. With Ready lighted, click the Learn button.
The controller will learn the car/counterweight position and the Done indicator will light. The
learned Counterweight position is displayed on the Setup > Counterweight tab.
7. Set the iBox Learn switch to OFF and the iBox Inspection switch to NORM.
3-28 Manual # 42-02-2222