MCi iControl User Manual page 388

Troubleshooting
Table 6.22 ICE-SAF Board Jumper Table
Jumper Setting
JP1
JP3
JP5
JP6
Table 6.23 ICE-SAF Board Switches
Switch
SW1 Serial Port switch: Setting for the Drive Serial Port (AC Drive / DC Drive). DC Drive set-
ting hard wired.
SW2 Encoder / Tach:
Encoder = AC drive with velocity encoder connected to AC drive.
Tach = DC drive or AC drive with velocity encoder connected to iBox VELOCITY inputs.
SW4 DCC Filter (ON / OFF) Default = ON, adds filtering to Drive Current Command output.
.
Table 6.24 iBox Field Connections on ICE-SAF Board
Source Connection
TS
TC
SHLD
DP1+
DP1-
SHLD
DP2+
DP2-
SHLD
A+
A-
B+
B-
Z+
Z-
VE-
VE+
6-112 Manual # 42-02-2222
A Encoder Voltage. A = +5V, B = +15V
AC Pre-Torque Filter (AC / DC): AC setting is hard wired, adds filtering to the
pre-torque output.
B Tach input range. A = 20-80V, B = 81-190V
B Tach input range. A = 20-80V, B = 81-190V
Tach positive signal. Analog. 0 - 30 VDC (15 VDC @ 1000 RPM).
Tach common (negative in respect to TS when car moving down)
Tach shield connection (connect at iBox-end only)
Positive going, +15V, digital pulse stream from iLand to iLink to iBox
(DP1 leads DP2 when car moves up).
tem" on page
Negative going, -15V, digital pulse stream from iLand to iLink to iBox.
Shield connection for twisted-pair DP1+/DP1-
Positive going, +15V, digital pulse stream from iLand to iLink to iBox
(DP2 leads DP1 when car moves down)
Negative going, -15V, digital pulse stream from iLand to iLink to iBox
Shield connection for twisted-pair DP2+/DP2-
Positive going, +12V, digital pulse from motor velocity encoder.
refer to "Velocity Encoder Installation and Wiring " on page
Negative going, -12V, digital pulse from motor velocity encoder.
Positive going, +12V, digital pulse from motor velocity encoder.
Negative going, -12V, digital pulse from motor velocity encoder.
Positive going, +12V, digital pulse from motor velocity encoder.
Negative going, -12V, digital pulse from motor velocity encoder.
Encoder power return
+12 VDC power to encoder (relative to VE-)
Description
Description
Signal Description
3-2.
Please refer to "iLand Landing Sys-
2-24.
Please