Speed; Speed Auto - Allied Telesis x310-26FT Command Reference Manual

S C
WITCHING OMMANDS

SPEED

speed
Overview This command changes the speed of the specified port. You can optionally specify
the speed or speeds that get autonegotiated, so autonegotiation is only
attempted at the specified speeds.
To see the currently-negotiated speed for ports whose links are up, use the
interface
default), use the
speed {10|100|auto [10][100]}
Syntax
The following table shows the speed options for each type of port.
Port type
RJ-45 copper ports
Mode Interface Configuration
Default By default, ports autonegotiate speed.
Usage Switch ports in a static or dynamic (LACP) channel group must have the same port
speed and be in full duplex mode. Once switch ports have been aggregated into a
channel group, you can set the speed of all the switch ports in the channel group
by applying this command to the channel group.
NOTE
then the device only attempts autonegotiation at those specified speeds.
Examples To set the speed of a copper port to 10Mbps, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To return the port to auto-negotiating its speed, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the port to auto-negotiate its speed at 10Mbps and 100Mbps, enter the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50103-01 REV A
command. To see the configured speed (when different from the
show running-config
Speed Options (units are Mbps)
auto (default)
10
100
: If multiple speeds are specified after the auto option to autonegotiate speeds,
configure terminal
interface port1.0.2
speed 10
configure terminal
interface port1.0.2

speed auto

configure terminal
interface port1.0.2
speed auto 10 100
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
command.
show
472