Debug Mstp (Rstp And Stp) - Allied Telesis x310-26FT Command Reference Manual

S T C
PANNING REE OMMANDS
(RSTP STP)
DEBUG MSTP AND

debug mstp (RSTP and STP)

Overview Use this command to enable debugging for the configured spanning tree mode,
and echo data to the console, at various levels. Note that although this command
uses the keyword mstp it displays debugging output for RSTP and STP protocols
as well the MSTP protocol.
Use the no variant of this command to disable spanning tree debugging.
debug mstp {all|cli|protocol [detail]|timer [detail]}
Syntax
debug mstp {packet {rx|tx} [decode] [interface <interface>]}
debug mstp {topology-change [interface <interface>]}
no debug mstp {all|cli|protocol [detail]|timer [detail]}
no debug mstp {packet {rx|tx} [decode] [interface <interface>]}
no debug mstp {topology-change [interface <interface>]}
Mode Privileged Exec and Global Configuration mode
Usage 1 Use the debug mstp topology-change interface command to generate
debugging messages when the device receives an indication of a topology change
in a BPDU from another device. The debugging can be activated on a per-port
basis. Although this command uses the keyword mstp, it displays debugging
output for RSTP and STP protocols as well as the MSTP protocol.
Due to the likely volume of output, these debug messages are best viewed using
the
C613-50103-01 REV A
Parameter
all
cli
packet
rx
tx
protocol
timer
detail
decode
topology-change
interface
<interface>
terminal monitor command before issuing the relevant debug mstp
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Echoes all spanning tree debugging levels to the console.
Echoes spanning tree commands to the console.
Echoes spanning tree packets to the console.
Received packets.
Transmitted packets.
Echoes protocol changes to the console.
Echoes timer information to the console.
Detailed output.
Interprets packet contents
Interprets topology change messages
Keyword before <interface> placeholder to specify an
interface to debug
Placeholder used to specify the name of the interface to
debug.
533