Switchport Vlan Translation - Allied Telesis x310-26FT Command Reference Manual

VLAN C
OMMANDS

SWITCHPORT VLAN TRANSLATION

switchport vlan translation
Overview Use this command to create a VLAN translation entry on an interface. The
translation entry translates a packet's VLAN-ID as seen on the wire.
Use the no variant of this command to remove all translation entries or a specific
entry.
This command can be applied to a switch port or a static channel group, or a
dynamic (LACP) channel group. The interface must be in a mode that supports
tagged packets.
switchport vlan translation vlan <wire-vid> vlan <vid>
Syntax
no switchport vlan translation [all|vlan <wire-vid>]
Default None (by default, no translation entries exist)
Mode Interface Configuration for a switch port or a static channel group, or a dynamic
(LACP) channel group. The interface must be in a mode that supports tagged
packets.
Example To translate VLAN100 to VLAN200 on port 1.0.1, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
100
Related show interface switchport vlan translation
Commands
switchport vlan translation default drop
C613-50103-01 REV A
Parameter
vlan <wire-vid>
vlan <vid>
all
configure terminal
interface port1.0.1
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
VLAN-ID of the packet as you want it to be seen on the wire.
VLAN-ID of the VLAN as it was assignedwhen the VLAN was
created.
Delete all translation entries.
switchport vlan translation vlan 200 vlan
513